DoorKing 1808 Telephone Access Plus - Manual (Page 36)

Page 36 1810-162-J-1-12
2.4 System Parameters Programming
IMPORTANT! We strongly suggest that you read these programming instructions in their
entirety before beginning any manual programming of the Access Plus unit.
The programming table on the next page provides a quick reference to the
Programming from the Keypad
Follow the programming instructions as described in each section of this manual. The unit will prompt
you with short tones (beep) when programming steps have been followed correctly and with a long
tone (beeeeeep) when the programming step is ended.
Programming with a Touch-Tone Telephone
Follow these steps when programming the Access Plus unit from an off-site touch-tone telephone.
NOTE: The Access Plus unit must be programmed to answer incoming calls, section 2.4.7.
1. Call the telephone number of the Access Plus unit. The Access Plus unit will answer with a
short beep after the programmed number of rings.
2. Follow the programming instructions as described in each section of this manual. The unit will
prompt you with short (beep) tones when programming steps have been followed correctly.
3. When complete, hang up.