DoorKing 1808 Telephone Access Plus - Manual (Page 41)

1810-162-J-1-12 Page 41
2.4.8 Hang Up Tone
Default setting is 0.
These steps set the number that will hang-up the Access Plus unit after conversation is completed.
1. Press * 1 7 and enter the MASTER CODE. [ * 1 7 _ _ _ _ (beep)]
2. Enter the hang up tone number then press *. [ _ * (beep)]
3. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.4.9 Call Waiting
Default setting is 1 (Call Waiting On).
This programming step is only used if the Access Plus unit is connected with the 1816 Access
Plus interface. This programming step is not applicable when the Access Plus unit is used as
an auto-dialer. These steps will turn the Call Waiting feature either ON or OFF. The call waiting
feature will allow the resident to place an outside call on hold when a visitor places a call from the
Access Plus unit to the resident through directory codes 01-23. Once communication with the visitor
is established, access can be granted or denied. If access is granted (press the number to open the
door or gate), the unit will automatically switch the call back to the outside call. If the resident wants
to deny access, they simply press the # key to switch back to the outside call.
1. Press * 2 0 and enter the MASTER CODE. [ * 2 0 _ _ _ _ (beep)]
2. Press 1 * to turn Call Waiting ON, OR 0 * to turn Call Waiting OFF. [ _ * (beep)]
3. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.4.10 Turn Speaker On
This command allows you to call the Access Plus unit from a remote location and turn on the speaker
at the unit to enable two-way voice communication and will allow relay control – all tone open
numbers that are programmed (2.4.8).
1. Call the phone number the Access Plus unit is installed on. After the programmed number of
rings (2.4.9) the unit will answer with a tone.
2. Press * 1 6 and enter the MASTER CODE. [ * 1 6 _ _ _ _ (beep)]
3. Hang up when your conversation is completed.