Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 36)

Classic Pro Gun Manual
Rev. 08/2012 Page | 36
A. To prevent the balls from falling through the trigger retainer, insert the tip of
the spool assembly into the trigger retainer.
Note: This is only temporary; the spool assembly will be inserted later in the
other end of the trigger retainer.
B.
Place a drop of Magnum Venus Pro Gun Oil™ (6706-3-1) into the trigger
retainer to help secure the balls.
C. Insert the ball (03198) in the trigger retainer, using a scribe to position the ball
into the detents in the trigger retainer.
3. Insert the o-ring (O-D-010) into the internal groove of the trigger retainer.
Note: Use the top of the spool assembly in the trigger retainer to prevent the o-
ring from falling through the retainer
4. Remove the tip of the spool assembly from the trigger retainer and reinsert the
spool assembly in the correct end of the trigger retainer. Rotate the shaft ¼ turn
as you push it in.
Note: Grease the end of the spool assembly with Pro Gun Oil (6706-3-1).
5. Screw the spool assembly to the trigger using Torx screw (02647-3).
6. Thoroughly lubricate the spool assembly and trigger retainer with Magnum Venus
Gun Oil (6706-3-1).
Attach Trigger Assembly to Handle
1. Insert the trigger assembly into the gun handle and secure with the fillister head
screw (F-FS-540-08) on the side of the handle.
Note: Be sure the front of the trigger retainer assembly is flush with the gun
handle before installing screw.
2. Install Trigger Hairpin (02970) as safety lock.