Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 34)

Classic Pro Gun Manual
Rev. 08/2012 Page | 34
Disassemble the Trigger Retainer
1. Remove the upper screw (02647-3) on the trigger.
2. Pull the trigger retainer (58648-1) off the spool assembly.
3. Remove the o-ring (O-D-010) from inside the trigger retainer.
Note: Be careful not to drop the chrome balls located inside the trigger retainer.
If your gun is used for gel coating, there will be no balls in the trigger retainer.
4. Remove the balls (03198) in the trigger retainer by inserting a small scribe
between the two o-rings and into each side hole of the retainer.
5. Remove the two o-rings (O-U-109) on the trigger retainer.
6. Remove the two o-rings (O-U-011) on the spool assembly.
Note: The spool assembly does not disassemble.
02970 (COTTER PIN)
O-U-011 (O-RING)
F-FS-540-08 (SCREW)
58624-1 (HANDLE)
58628-1 (TRIGGER BUSHING)
58628-1-SS (BUSHING
– SS)
58647-1 (VALVE ASSY)
58629-1 (GUIDE PIN)
58629-3 (PIN -NO LOCK)
58629-1-SS (GUIDE PIN
– SS)
03198 (BALL)
O-U-109 (O-RING) O-D-010 (O-RING)
58648-1 (RETAINER)
TRIGGER
SCREW