Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 17)

Classic Pro Gun Manual
Rev. 08/2012 Page | 17
Release System Pressure
1. Turn off air supply to pumping system.
2. Release fluid pressure from lines by holding the gun over an appropriate empty
container and pulling the trigger.
3. Flush gun into appropriate container
4. Turn off air supply to the solvent tank.
5. Release any pressure in the flush tank by gently pulling upwards on the ring
attached to the pressure relief valve.
6. Disconnect air line from rear of gun handle.
7. Place an empty container under the ball valve located at the bottom of the filter
assembly.
8. SLOWLY open the ball valve, you can leave the ball valve open or close it when
the all the pressure has been released.
Disable Catalyst Pump
Slave Arm pumps
1.
Remove the quick pin from the top of the catalyst pump and upper slave arm.
2.
Tilt the catalyst pump away from the resin pump until the catalyst pump is resting
against the vertical connecting post.
3.
Trap the catalyst pump’s upper bearing block between the vertical connecting
post and the quick pin.
Ultra Proportioning System (UPS)
1.
Remove the hairpin from the quick pin assembly.
2.
Remove the quick pin assembly from the pivot link assembly