Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 26)

Classic Pro Gun Manual
Rev. 08/2012 Page | 26
Align Catalyst Seal
1. Hold the catalyst alignment tool (6705-3-1) (tapered drill bit) firmly with a pair of
pliers.
2. Insert the catalyst alignment tool (tapered end first) into the gun block through the
rear of the gun block
3. Gently press and move the alignment tool around until the holes in the catalyst
seal aligns with the hole / port in the gun block.
Note: At this point, the catalyst side packing nut should only be hand tight.
Reassemble Resin Components
1. Place the resin components onto the seal installation tool in the following order:

Packing ring (5104-7-1)

Resin seal (5104-5-1)

Relief spacer (5104-4-1)
Note: Before inserting the packing tool, align the hole in the resin seal with the
hole in the gun block as closely as possible
2. Insert the seal installation tool into the resin side of the gun block. Tap gently with
a rubber mallet or hammer, and then pull the packing tool out of the gun block.
3. The resin components should be seated in the interior of the gun block against
the center spacer.
4. Gently screw a packing nut (5104-8-1) into the resin side. Do not tighten.
Align Resin Seal
1. Hold the resin alignment tool (6705-4-1) (tapered drill bit) firmly with a pair of
pliers.
2. Insert the resin alignment tool (tapered end first) into the gun block through the
rear of the gun block.
3. Gently move the resin alignment tool inside the gun block so that the holes in the
resin seal aligns with the hole / port in the gun block.
Note: At this point, the resin side packing nut should only be hand tight.