Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 15)

Classic Pro Gun Manual
Rev. 08/2012 Page | 15
Introduction:
The Pro Gun is an air trigger gun; meaning when the trigger is pulled an air cylinder
pushes on the actuator stem and rotates the gun block into the on position. The Pro
Gun works very similar to a dual ball valve in that the valve rod rotates and the catalyst
and resin holes line up with the ports in the gun block allowing material to flow. The
actuator is an air cylinder and as the piston moves back and forth it rotates the valve rod
90 degrees to the on or off position.
Generally, the Pro Gun ™ will not need to be completely disassembled for daily
cleaning. However, the entire gun should be disassembled and the o-rings and seals
replaced approximately every six months.
Disassembling the Pro Gun™ is easy; the gun breaks down into four separate modules
which are then disassembled further into their individual parts. A special tool kit, which
includes a specially designed Pro Gun
™ tool and a packing assembly tool, is available
to aid in performing maintenance and repair.
This manual, the CLASSIC PRO GUN REPAIR MANUAL, provides information you
need to perform simple maintenance and repair on your equipment.
 Step-by-step assembly and disassembly procedures are included for each
component.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
DANGER: Always wear proper safety equipment, including eye protection and gloves
when performing service and repair on this equipment.
During Disassembly:
As you disassemble the equipment, lay out the components on a clean surface in the
correct order and direction. This will help you to reassemble them.