Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 16)

Classic Pro Gun Manual
Rev. 08/2012 Page | 16
This manual covers the following Classic Pro Gun assemblies:
CPG-1000-W CLASSIC PRO GUN ASSEMBLY
– WETOUT
CPG-1000-X PRO GEL COAT GUN
CPG-1000-X-INT PRO GEL COAT GUN
– INTERNATIONAL
CPG-2000-X PRO GEL COAT GUN – FIT
CPG-2000-X-INT PRO GEL COAT GUN
– INTERNATIONAL FIT
CPC-1000-X CLASSIC PRO CHOPPER GUN
CPC-1000-X-INT CLASSIC PRO CHOPPER GUN
– INTERNATIONAL
CPC-2000-X CLASSIC PRO CHOPPER GUN – FIT
CPC-2000-X-INT CLASSIC PRO CHOPPER GUN – INTERNATIONAL FIT
CPP-3000 CLASSIC PRO GUN ASSEMBLY
– SPRAY PUTTY
CPP-6000 CLASSIC PRO GUN ASSEMBLY – PUTTY POUR
CPW-1000-X CLASSIC PRO GUN ASSEMBLY
– WETOUT
CPW-1000-X-INT CLASSIC PRO GUN ASSEMBLY – INTERNATIONAL WETOUT
CPW-2000-X CLASSIC PRO GUN ASSEMBLY
– FIT
CPW-2000-X-INT CLASSIC PRO GUN ASSEMBLY – INTERNATIONAL FIT
CPW-4000 CLASSIC PRO GUN ASSEMBLY
– FIT REVERSIBLE TIP
Tools required
You will need the following tools:

Rubber mallet

Thread Sealant

Adjustable wrench

Needle-nose pliers

Flat-end screwdriver
 Lubriplate™ lubricant (08465)

Scribe set (08126)
 Pro Gun ™ oil (04394)

Turbulent Mixer Puller (6705-2-1)

Seal Installation tool (58661-1)

Alignment tool for resin seals (58663-1)

Alignment tool for catalyst seals (58662-1)
 Pro Gun ™ screwdriver (9301-3-2) and packing bit (6705-1-1)
You should also have appropriate cleaning materials such as solvent, clean shop towels
or rags, a small brush, and empty containers into which you will flush the gun.
Also, you will need new o-
rings and seals to replace the current ones in the Pro Gun™.
Please refer to the parts drawings to obtain proper parts numbers for the o-rings and
seals to be replaced.
Note: If you are using o-ring part number 01128 in the gun block, you do not need
to replace the o-ring unless it is showing obvious signs of wear. This o-ring is
specially designed to handle most solvents