beautypg.com

Remove hose fittings, Remove valve rod, Remove center spacer – Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP User Manual

Page 22

background image

Classic Pro Gun Manual

Rev. 08/2012

Page | 22

Remove Hose Fittings

1.

Remove and clean the catalyst fitting and o-ring on the rear of the gun block.

2.

Remove and clean the resin fitting and o-ring on the rear of the gun block.

Remove Valve Rod

1.

Use the magnetic handle and packing bit to unscrew the packing nuts (5104-8-1)
from both the catalyst and resin side. Use caution not to damage the packing bit.
If you are unable to remove the packing nut soak in a solvent or apply heat to the
packing nuts.

2.

Place the small end of the seal installation tool onto one end of the valve rod.

3.

Use a rubber mallet or hammer to gently tap the valve rod out of the gun block.

4.

Inspect the valve rod for damage; clean with solvent.

PACKING NUT

VALVE ROD

SEAL INSTALLATION TOOL


Remove Center Spacer

1.

Use needle-nose pliers to remove the center spacer (5104-10-1).

CENTER SPACER