Controlled Products Systems Group 9050-080 - Manual (Page 33)

9050-065-M-3-11 31
SECTION 6 - OPERATING INSTRUCTIONS
WARNING - To reduce the risk of injury or death:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Never let children operate or play with gate controls. Keep the remote control away from children.
3. Always keep people and objects away from gate. NO ONE SHOULD CROSS THE PATH OF THE MOVING GATE .
4. Test the operator monthly. The gate MUST reverse on contact with a rigid object or stop or reverse when an object
activates the non-contact sensors. After adjusting the force or the limit of travel, retest the gate operator. Failure to
adjust and retest the gate operator properly can increase the risk of injury or death.
5. Use the emergency release only when the gate is not moving and power has been shut-off.
6. KEEP GATES PROPERLY MAINTAINED. Read the owner's manual. Have a qualified service person make repairs to gate
hardware.
7. The entrance is for vehicles only. Pedestrians must use separate entrance.
8. SAVE THESE INSTRUCTIONS .
Unlock the power switch cover and open to access
the Main Power, and the operator Reset Button.
AC
POWER
OFF
RESET
6.1 AC Power Switch and Reset Button
Reset Button - Used to turn off
the entrapment alarm and to
reset the operator after a HARD
shutdown has occurred.
Alarm Siren
AC Power Switch - Powers the
operator ON (toggle up) or
OFF (toggle down).
IMPORTANT SAFETY INSTRUCTIONS
W ARNI
NG
MO VI NG G ATE CAN CAU
SE
Op era te ga te o nly w hen ga te a rea is i n s igh t
and fre e o f pe ople an d o bstr ucti ons .
Do no t all ow ch ildr en t o p lay in g ate are a
or o per ate ga te.
Do no t sta nd i n g ate pa th o r w alk thro ugh
path w hile ga te is m ovin g.
Re ad o wn er’s m anu al a nd s afe ty in stru ctio ns.
SER IO US IN JU RY OR DEA TH
CLA SS
CER TIF IED TO
CA N/C SA C2 2.2 NO . 2 47
CO NF OR MS TO AN SI/U L-3 25
VE HI CUL AR GA TE O PE RA TOR HP
533 82
MO DE L SER IAL VO LTS
PH AS E
AMP S
60 H z
MA X G ATE LO AD Doo rKin g, In c., I ngle wo od, CA
Every time the operator is powered up, the First open command will automatically run “Multiple
gate cycles” that will locate and remember the gate’s open and close positions (See page 22).
Important: The operator
WILL NOT lose its open
and close limit positions
after pressing the reset
button.