Controlled Products Systems Group 9050-080 - Manual (Page 3)

9050-065-M-3-11 1
DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any
persons of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is
copyrighted, all rights reserved. No portion of this manual may be copied, reproduced, translated, or reduced to any electronic medium without prior written
consent from DoorKing, Inc.
11.5” 12”
14.75”
24”
Concrete
Pad
Gate Frame
1” Minimum
4” Minimum
UL 325 Class I
Vehicular Slide Gates Only
1/2 HP
115 VAC Single-Phase
4.3 Amps @ 120V
300 Lbs.
16 Ft.
#40 Chain
20 Per Hour
Approximately 1 Ft. per Second
Primary - Inherent entrapment sensing system (Type A)
Secondary - Provision for connection of a non-contact sensor (Type B1)
and/or a contact sensor (Type B2).
Class of Operation
Type of Gate
Horsepower
Voltage / Phase
Current
Max Gate Weight (Installed level)
Max Gate Length (Installed level)
Drive Sprocket Size
Cycles Per Hour
Speed
Entrapment Protection
SPECIFICATIONS
WARNING
MOVING GATE CAN CAUSE
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner’s manual and safety instructions.
SERIOUS INJURY OR DEATH
CLASS
CERTIFIED TO CAN/CSA C22.2 NO. 247
CONFORMS TO ANSI/UL-325
VEHICULAR GATE OPERATOR
HP
53382
MODEL
SERIAL
VOLTS PHASE
AMPS 60 Hz
MAX GATE LOAD
DoorKing, Inc., Inglewood, CA
10.5”
Chain Height:
Idler wheels in
top position.
Use this manual for the Model 9050
operator with circuit board 4702-010
Rev A or higher ONLY.
Concrete
Pad