Controlled Products Systems Group 9050-080 - Manual (Page 18)

9050-065-M-3-11 16
4”
11”
Solenoid
Lock
Conduit Area
2.5”
Electronic Box
1.6 Pad, Post or Ceiling Mount without/with J-Box Setup
Post Mount with Conduit
Pad Mount with Conduit
15”
Min.
21” Min.
Concrete Pad
Center
Concrete Pad
Concrete Foundation Conduit
Concrete Foundation
1” minimum from operator housing to gate.
4” min. above ground.
4” min. above ground.
1” minimum from operator housing to gate.
Underground depth of the
concrete pad is determined
by soil conditions and local
building codes. Reinforced
concrete recommended.
Underground depth of the
concrete foundation is
determined by soil
conditions and local
building codes. Reinforced
concrete recommended.
Concrete pad
MUST be level.
Base Plate
MUST be level.
Operator MUST
be level.
Conduit
area
inside
post.
Conduit
area
inside
post.
Pad, Post or Ceiling Mount Connected with Junction Boxes
All wire connections
can be made on
either side of the
operator housing after
it has been installed.
Never run high
voltage and low
voltage in the
same conduit.
Conduit Knock-Out Sizes
Low
Volt High
Volt
1/2 1/2
3/4 1/2
Fail-Secure
Key Lock
1/2
3/4 1/2
Note: Weld the posts to the base plate and mount
assembly into concrete BEFORE attaching the
operator. Conduit runs up through 4 x 4 steel posts.
Note: Operator must be mounted
1” min. away from gate.
Low
Volt High
Volt
WARNING
MOVING GATE CAN CAUSE
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner’s manual and safety instructions. SERIOUS INJURY OR DEATH
CLASS
CERTIFIED TO CAN/CSA C22.2 NO. 247
CONFORMS TO ANSI/UL-325
VEHICULAR GATE OPERATOR HP
53382
MODEL SERIAL VOLTS PHASE AMPS 60 Hz MAX GATE LOAD DoorKing, Inc., Inglewood, CA
Conduit Conduit
Base Plate
P/N 2600-418
Pad, post or
ceiling mount
Conduit
12”
Min.
21”
Min.