Controlled Products Systems Group 9050-080 - Manual (Page 15)

9050-065-M-3-11 13
• Set one chain Idler wheel at the top and one in the
center position on one side of the operator.
• Remove both chain knockouts from one side of the
operator.
• Chain stops or gate end retainer can be
used as the physical stop for the gate
(Chain stops are shown).
Additional hardware required. Endless idler assembly (P/N 2600-818) and additional chain #40 (P/N 2600-442 - 20 ft. per box)
may be needed.
Additional hardware required. Post base plate (P/N 2600-418) 4 x 4 steel posts not available from DoorKing.
Rear Position with Concrete Pad
Hides the chain from outside the property looking in.
• Chain setup is the same as above.
Rear Position with Post Mount
Hides the chain from outside the property looking in.
Endless
Idler
Chain Idler
Wheels
Chain
Stop
Chain Setup
Top View
See page 18 for
more information
about endless idlers.
A filler post or barrier may need to be
installed between the gate and wall area
(See page 8 for more information).