Controlled Products Systems Group 6400-080 - Manual (Page 26)

6400-065-E-05-07 26 6400 installation guide
The following accessories are available for 6001 / 6002
actuators.
Photo Cell:
Non-contact (photo-cells) sensors are used as secondary
entrapment protection.
EMX Industries, Inc., Model IRB-325
MMTC, Inc., Model E3K-R10K4-NR
Loop Detector:
Detectors plug directly into ports on circuit board.
P/N 9405-010 - Single channel detector
P/N 9406-010 - Two-channel detector
Magnetic Lock:
Magnetic locks provide secure swing gates and is a fail-safe
device allowing emergency vehicle access during power
outages.
P/N 1216-080 or 1216-081
Time Clock:
7 day and 365 day time clocks can be used to automatically
open gate at pre-set time and days. Compact clock fi ts inside
the operator.
P/N 2600-791 - 7-day clock
P/N 2600-795 - 365-day clock
Torsion Rods:
Torsion rod assembly is used on uphill swing gates for
counter balance.
P/N 1203-083
Hinges:
Heavy-duty ball bearing hinges provide easy swing gate
operation.
P/N 1200-009 - Two (2) required.
Surge Devices:
High and low voltage surge suppressors help prevent circuit
board failure caused by lightning strikes and power surges.
P/N 1876-010 - High Voltage
P/N 1878-010 - Low Voltage
Gate Scale:
Test torque required to move gate.
P/N 2600-225
Speed Bumps:
Prefabricated six-foot speed bump reduces traffi c speed
through gate system.
P/N 1610-150
Batteries:
12 Volt 3 Amp Hour
P/N 1801-009 - Two (2) required
Fuse:
5 Amp
P/N 4601-058
technical information / accessories
5