Controlled Products Systems Group 6002-080 - Manual (Page 21)

19
2.6 High Voltage Wiring and Battery Connection
Connect 115 VAC input
power wires (black and
white) to black and
white transformer wires.
Connect input green
wire to chassis ground.
Note: To turn-off ALL power to the operator, the AC
power switch must be turned off and the battery
plug must be disconnected from the circuit board.
After power has been
connected, activate the
actuator arm by pressing
the key switch button.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 RED 24V RED BLK 115V WHT
Chassis
Ground
Alarm
Reset
Reset Button
It is recommended that a surge suppressor be installed on the high voltage power lines.
DANGER
HIGH VOLTAGE!
CAUTION
Do not connect the battery to
the circuit board until power is
needed to test the actuator arm.
1
7
6
5
4
3
2
CONTROL BOX MUST BE PROPERLY GROUNDED!!
4302
Power Power
Switch Switch
AC AC
12 V
o
lt 3 Amp/Hr Batter
y
12 V
o
lt 3 Amp/Hr Batter
y
6002-065-M-6-08