Controlled Products Systems Group 6002-080 - Manual (Page 12)

10
6002-065-M-6-08
1.2 Gate “Opens to the Inside” Bracket Locations
46 3 / 4 ” Closed Position
7”
7”
90°
Gate Hinge Pivot Point
Reinforced
Steel Plate
Concrete
Sleeve
Anchors Bolts with
Lock Washers
Reinforced
Steel Plate
Front Bracket Pivot Point
Rear Bracket
Rear Bracket
Front Bracket
Front Bracket
Rear Bracket Pivot Point
Open Position
(Cover On)
Closed Position
(Cover Off)
A support bar must span
the entire length of the
gate to support the gate
pickets. The pickets will
bend if not supported.
Support Bar
Do not install the actuator in fully
extended (Bottomed out) position.
This will damage the arm.
3 1 / 8 ”
Mechanically Attaching Brackets
to Surfaces
When mounting brackets with bolts
to the wall and/or gate, weld reinforcing steel plates to the
brackets. Completely weld around brackets. The brackets
must be perpendicular to the wall and/or gate and
horizontally level.
Gate in Closed Position
Actuator arm and brackets MUST be level!