CTI Products TSAM Transmitter Steering & Audio Matrix User Manual
Page 56

TSAM Installation and Maintenance Rev. 2.10
Chapter 5
CTI Products, Inc.
Setting Programmable Options
48
5.6.6
DI: Disabling individual transmitters for multicast
Use the DI command to disable individual transmitters for multicast. The DI command lets you enter a
number of transmitters if you wish. End each entry with a
deleting transmitters, enter a 0
command.
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: EA
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: DI
Enter Transmitter Number (1-64) to Disable
(1-64, or 0 to Quit)? --> : 1
(1-64, or 0 to Quit)? --> : 3
(1-64, or 0 to Quit)? --> : 5
(1-64, or 0 to Quit)? --> : 7
(1-64, or 0 to Quit)? --> : 9
(1-64, or 0 to Quit)? --> : 11
(1-64, or 0 to Quit)? --> : 0
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: L
TSAM(1) Y TX: __ 2 __ 4 __ 6 __ 8
TSAM(2) Y TX: __ 10 __ 12 13 14 15 16
TSAM(3) N TX: 17 18 19 20 21 22 23 24
TSAM(4) N TX: 25 26 27 28 29 30 31 32
TSAM(5) N TX: 33 34 35 36 37 38 39 40
TSAM(6) N TX: 41 42 43 44 45 46 47 48
TSAM(7) N TX: 49 50 51 52 53 54 55 56
TSAM(8) N TX: 57 58 59 60 61 62 63 64
Note that the DI command works with the currently enabled transmitters. In this case we first used the EA
command to enable all transmitters and then used the DI command to disable the transmitters we didn't
want.