Expansion unit programming, Physical installation of tsam, Figure 6 tsam mounting positions – CTI Products TSAM Transmitter Steering & Audio Matrix User Manual
Page 29: 3 expansion unit programming, 3 physical installation of tsam
TSAM Installation and Maintenance Rev. 2.10
Chapter 4
CTI Products, Inc.
Installation
21
4.2.3
Expansion Unit Programming
When a system is programmed for a slave (expansion) TSAM and the slave unit is disconnected, the
system must be reprogrammed to insure proper operation. If you must run a system with an expansion unit
disconnected, re-program the master TSAM for one less expansion unit. Be sure that the expansion units
are addressed sequentially.
4.3
Physical installation of TSAM
A set of rack mount ears are furnished with the TSAM. There are two mounting locations on the TSAM
enclosure for the mounting ears. There are two sets of mounting holes in the ears. The ears may be
mounted with the mounting flange forward or reversed. These options allow the TSAM to be mounted in
any of 8 positions. This allows mounting in a variety of racks or cabinets.
Figure 6 TSAM Mounting Positions
- MCN RCD System Overview (46 pages)
- MCN RCD System Planner (53 pages)
- RCD Standard - Remote Comparator Display (2 pages)
- RCD Standard - Remote Comparator Display (119 pages)
- RCD Client-Server (2 pages)
- RCD Advanced Client-Server (169 pages)
- RCD Advanced Client-Server (2 pages)
- MCN Server 8000 (3 pages)
- MCN Server 8000 (232 pages)
- EXB Network Manager (48 pages)
- HIB-IP IP Interface (2 pages)
- HIB-IP IP Interface (36 pages)
- HIB-232 Serial Interface (2 pages)
- HIB-232 Serial Interface (19 pages)
- PCLTA PCI Interface (2 pages)
- PCLTA PCI Interface (33 pages)
- IIB Console Interface (2 pages)
- IIB Console Interface (26 pages)
- CIB Comparator Interface (2 pages)
- CIB Comparator Interface (40 pages)
- AIB AstroTAC Interface (2 pages)
- AIB AstroTAC Interface (19 pages)
- EXB-IM PSTN System Extender (4 pages)
- EXB-IP Ethernet System Extender (63 pages)
- EXB-IM PSTN System Extender (31 pages)
- GPIO General Purpose I/O Interface (3 pages)
- GPIO General Purpose I/O Interface (26 pages)
- GPIO-CVT Buffer/Logic Converter (2 pages)
- IOB I/O Interface (33 pages)
- CHIB CommandSTAR Lite Host Interface Module (22 pages)
- CCU Channel Control Unit (24 pages)
- CCU-2 Channel Control Unit (21 pages)
- RYB-8 Relay Board (2 pages)
- RYB-8 Relay Board (17 pages)
- Quad Router Panel (2 pages)
- OTAL On-the-Air Driver Assembly (22 pages)
- OTAL On-the Air Terminal Board and Lamp (14 pages)
- DC Distribution Panel (9 pages)
- TSAM Transmitter Steering & Audio Matrix (2 pages)
- TIB TSAM Interface (2 pages)
- TIB TSAM Interface (24 pages)
- TurboVUi Solo Client Software (1 page)
- TurboVUi Solo Client Software (12 pages)
- TurboVUi Solo Client Software (16 pages)