CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 15)

TSAM Installation and Maintenance Rev. 2.10 Chapter 2
CTI Products, Inc. Main Channel Operation
7
Since the Smart-Steer  algorithm does not complete vote processing until the end of current receiver
activity, it must use the End of Receive Update Mode.
2.2.3 Instant Update Input
This input can be used to switch between End of Receive Update Mode and Instant Update Mode from the
console. To do this, program the TSAM for End of Receive Update Mode. When the Instant Update
Input is active (low), the TSAM unit will use the First Receiver instant update steering mode on the next
reception. If the TSAM is already programmed for First Receive instant update steering, the input has no
effect.
2.2.4 Fast Steer On Console 1 PTT
TSAM firmware versions 1.60 and later provide a feature that allows the TSAM to steer when Console 1
PTT becomes active, even if receivers are active. This feature is functional only when the steering method
is programmed for Integrated Vote and the Fast Steer option is enabled. This feature allows faster console
transmit operation. The default setting for the Fast Steer option is enabled. It can be programmed in the
TX Steering Menu Integrated Vote section. It is recommended that this option be used whenever the
Smart-Steer™ Integrated Vote algorithm is used.