L: listing enabled multicast transmitters, 2 l: listing enabled multicast transmitters – CTI Products TSAM Transmitter Steering & Audio Matrix User Manual
Page 52

TSAM Installation and Maintenance Rev. 2.10
Chapter 5
CTI Products, Inc.
Setting Programmable Options
44
5.6.2
L: Listing Enabled Multicast Transmitters
You can list the enabled multicast transmitters with the L command as shown below. There is a matrix of
8 transmitters and 8 TSAM units.
(EA/EI/DA/DI/L/Q)? -->
: EA
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: L
TSAM(1) Y TX: 1 2 3 4 5 6 7 8
TSAM(2) N TX: __ __ __ __ __ __ __ __
TSAM(3) N TX: __ __ __ __ __ __ __ __
TSAM(4) N TX: __ __ __ __ __ __ __ __
TSAM(5) N TX: __ __ __ __ __ __ __ __
TSAM(6) N TX: __ __ __ __ __ __ __ __
TSAM(7) N TX: __ __ __ __ __ __ __ __
TSAM(8) N TX: __ __ __ __ __ __ __ __
Enabled transmitters are shown with their number. (Transmitters 1-8 here)
Disabled transmitters are shown with a blank (__). (Transmitters 9-64 here)
Active TSAM units have a "Y" following their number.
Inactive TSAM units have an "N" following their number.
Only transmitters with active TSAM units will transmit on Multicast. To activate additional TSAM units,
use the "X" command from the main menu.
Use the L (List) command to verify your selection before quitting the Multicast menu.