CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 45)

TSAM Installation and Maintenance Rev. 2.10 Chapter 5
CTI Products, Inc. Setting Programmable Options
37
5. Setting Programmable Options
Many TSAM operational parameters are set in software. To edit these programmable options, connect a
dumb terminal (or a PC with a terminal emulator) to the TSAM programming port.
5.1 Terminal Connections & Settings
TSAM Programming Port DE-9S DCE
9-Pin Female to match PC-AT port
Cable Requirements: Straight-through 9-Pin RS-232
9-Pin Male to Female for PC-AT Port
25 to 9 Pin adapter required for 25-pin port
Data Format: 9600 baud, no parity, and 1 stop bit (9600,N,8,1)
Terminal Emulation: None
5.2 Main Menu
After connecting to the TSAM programming port, reset the TSAM. The following reset message will
appear:
Transmitter Steering Audio Matrix TSX V1.70
Copyright 1993-2001, Combined Technologies Inc., Cincinnati, Ohio
All Rights Reserved
Press 3 times to activate programming menu
***** Warning! *****
Transmitter Steering is disabled while programming menu is active!
Figure 13 Programming Screen
After the reset sequence is complete (typically 1 second), press the Escape key 3 times to activate the
programming menu. While in the programming menu, the TSAM stops transmitter steering and terminates
any transmissions in progress on the Main or secondary channels.
When you enter the programming menu, the TSAM displays a list of parameter menus available for
viewing and editing.