Front panel indicators, 13 front panel indicators – CTI Products TSAM Transmitter Steering & Audio Matrix User Manual
Page 41
TSAM Installation and Maintenance Rev. 2.10
Chapter 4
CTI Products, Inc.
Installation
33
4.13
Front Panel Indicators
The TSAM has several front panel LED indictors used to display operational status and diagnostic
information.
Reset
This indicator lights when the reset line is held low. This LED should be lit when the front panel reset
button is pressed or the TSAM is initially powered.
Vote
The vote led indicates the start of the steering process. This LED is lit when a voted site is detected and the
Free Vote Time has expired. the vote has ended The LED remains lit until the Fade Hold time expires.
Active
This indicator is lit when the TSAM successfully powers up and initializes itself. The indicator should
always be lit. A problem exists if the indicator is not lit.
Master
This LED indicates when a TSAM is configured as a master unit (SW102-4 is up). Only one TSAM on a
steered channel can be a master, all other TSAMs must be slave units.
- MCN RCD System Overview (46 pages)
- MCN RCD System Planner (53 pages)
- RCD Standard - Remote Comparator Display (2 pages)
- RCD Standard - Remote Comparator Display (119 pages)
- RCD Client-Server (2 pages)
- RCD Advanced Client-Server (169 pages)
- RCD Advanced Client-Server (2 pages)
- MCN Server 8000 (3 pages)
- MCN Server 8000 (232 pages)
- EXB Network Manager (48 pages)
- HIB-IP IP Interface (2 pages)
- HIB-IP IP Interface (36 pages)
- HIB-232 Serial Interface (2 pages)
- HIB-232 Serial Interface (19 pages)
- PCLTA PCI Interface (2 pages)
- PCLTA PCI Interface (33 pages)
- IIB Console Interface (2 pages)
- IIB Console Interface (26 pages)
- CIB Comparator Interface (2 pages)
- CIB Comparator Interface (40 pages)
- AIB AstroTAC Interface (2 pages)
- AIB AstroTAC Interface (19 pages)
- EXB-IM PSTN System Extender (4 pages)
- EXB-IP Ethernet System Extender (63 pages)
- EXB-IM PSTN System Extender (31 pages)
- GPIO General Purpose I/O Interface (3 pages)
- GPIO General Purpose I/O Interface (26 pages)
- GPIO-CVT Buffer/Logic Converter (2 pages)
- IOB I/O Interface (33 pages)
- CHIB CommandSTAR Lite Host Interface Module (22 pages)
- CCU Channel Control Unit (24 pages)
- CCU-2 Channel Control Unit (21 pages)
- RYB-8 Relay Board (2 pages)
- RYB-8 Relay Board (17 pages)
- Quad Router Panel (2 pages)
- OTAL On-the-Air Driver Assembly (22 pages)
- OTAL On-the Air Terminal Board and Lamp (14 pages)
- DC Distribution Panel (9 pages)
- TSAM Transmitter Steering & Audio Matrix (2 pages)
- TIB TSAM Interface (2 pages)
- TIB TSAM Interface (24 pages)
- TurboVUi Solo Client Software (1 page)
- TurboVUi Solo Client Software (12 pages)
- TurboVUi Solo Client Software (16 pages)