CTI Products EXB-IP Ethernet System Extender - Manual (Page 37)

CTI Products, Inc. EXB-IP User Guide
Glossary 37
5. G
LOSSARY
EXB-IP module Network Extender Module used with CTI's MCN Networks to extend a network from
one location to another over an IP channel
EXB-IP Legacy Module EXB-IP modules with a version number below 400. The Legacy modules used a fixed
input UDP port of 1100 and did not support user-configurable UDP Port numbers.
In the UDP Port field, EXB-IP Legacy is used to select the proper fixed port for
communication between modules if there are any Legacy EXB-IP modules in the
channel.
EXB-IP Legacy Port A destination UDP Port of 1100 as used by Legacy EXB-IP modules. EXB-IP 8000
modules can also be configured to use this Port to communicate with legacy EXB-IP
modules.
EXB-IP 8000 Module EXB-IP modules with a version number of 400 and above. These modules used a user-
configurable input UDP port. In Motorola Solutions, Inc. Astro25™ networks ( 7.13
and above), a fixed UDP port has been reserved for the EXB-IP modules for
communication across the Radio Network Infrastructure (RNI). This UDP port is used
when EXB-IP 8000 is selected in the UDP Port field. The EXB-IP 8000 setting cannot
be used if there any Legacy EXB-IP modules in the channel.
EXB-IP 8000 Port A destination UDP Port compatible with Motorola Solutions, Inc. Astro™25 Radio
Network Infrastructure version 7.13 and above.
Channel In general, the "Channel" is used in this manual to indicate all the EXB-IP modules that
will communicate with each other, along with the IP network (LANs and WAN)
connecting those modules.
Com Port Synonymous with RS-232 port
Gateway If EXB-IP modules reside on a different IP Subnets, they must communicate through
IP routers. The Gateway is the IP address of the port of the router closest to the EXB-
IP module. The Gateway Address associated with a member EXB-IP module must be
in the same subnet as that EXB-IP module.
IP Internet Protocol.. IP Version 4 is used by the EXB-IP modules.
IP address Logical network address used for IP communication in an IPV4 network. In the EXB
Config program it is specified as four octets (ex: 192.168.2.7).
IPV4 Internet Protocol Version 4
I/O Input and output.
MCN™ CTI Products' Monitoring and Control Network
Member One of the EXB-IP modules in a Channel