CONTREX ML-Drive - Manual (Page 48)

3 - 14
Table 3-8 Default Follower Scaling Control Parameters
CP Parameter Name Parameter Value
CP-33 Max RPM Lead 2000
CP-34 Max RPM Feedback 2000
CP-30 PPR Lead 60
CP-31 PPR Feedback 60
CP-21 Follower Engineering Units 1.000
Table 3-9 Entering Follower Scaling Control Parameters
CP Parameter Name Parameter Value
CP-33 Max RPM Lead
CP-34 Max RPM Feedback
CP-33 PPR Lead
CP-31 PPR Feedback
CP-21 Follower Engineering Units
Enter the maximum operating RPM of
the Lead motor, measured at the Lead
sensor shaft (pulses per revolution).
Enter the maximum desired RPM of the
Follower motor, measured at the
Follower feedback sensor shaft.
Enter the number of gear teeth or
encoder lines on the Lead sensor.
Enter the number of gear teeth or
encoder lines on the Follower
feedback sensor.
Enter the Engineering Units value if the
Lead (CP-33) is operating at maximum
RPM and the Follower (CP-34) is
operating at maximum RPM.