Hach-Lange ORBISPHERE K1100_M1100 Operator Manual - Manual (Page 88)

86
Communication Menu
9.6 Printer
This menu provides the facility to print a number of reports directly to a printer. The printer must
be connected to the instrument through the instrument USB-B 4-pin port.
The following information is available for printing:
• Calibration reports
• User action log files
• Instrument configuration details
• Measurements stored in the instrument memory
• Cyclic measurements for continuous printing
9.6.1 Printer error messages
Note: Cyclic measurement mode is automatically disabled when an error occurs. After the error is
corrected, reactivate the cyclic mode in the report configuration option if cyclic measurements are required.
Configuration
Printer configuration Currently only the USB port is a valid printer connection.
Report configuration
Calibration - Choose the channel(s) for which calibration reports are
required. Choose to print the last report or all reports for the selected
channel(s).
User actions
- Define the date and time criteria for which user action logs
are required.
Configuration
- Choose the channel(s) for which instrument configuration
details are required.
Measurements
- Choose the channel(s) for which measurement reports are
required. Define the start and end times for the measurement reports.
Cyclic measurements
- Check the enable continuous mode checkbox and
choose the channel(s) for which cyclic measurements are required.
Cancel
- Exit the configuration option.
Send files
Choose the report (or All) to print the reports that match the configuration criteria. A status bar
at the top of the screen shows printing progress.
Push the Cancel button to cancel a print job.
Error message Meaning
Printer not available
Indicates that no printer has been detected. Check that the printer is
connected to the USB-B port and is powered on.
Paper out
Indicates that the printer is out of paper. In cyclic mode, it is necessary to
activate cyclic printing after reloading paper in the printer. In other modes,
printing can be restarted directly.
Unknown error
An unidentified error has been detected that prevents printing. If this error
occurs, refer to the printer User Manual to identify the cause of the problem.