Cashco Siemens PS2 I/P - Manual (Page 77)

Operation
77
SIPART PS2 Manual
A5E00074631-01
The display of the positioner shows you the current potentiometer
setting in the top line and ”NOINIT” flashes in the second line. You can
move the actuator with the decrement and increment key
. In order
to adapt the positioner to your actuator, you have to change to the
Configuration menu. See also chapter 3.6, page 57 “Commissioning”.
Output of alarms and position feedback is possible after successful in-
itialization.
To go to the Configuration menu, press the operation mode key for
at least 5 seconds. In the Configuration menu you can adapt the
positioner individually to your actuator and start initialization. Only a few
parameters need to be set in the positioner prior to initialization. The
others are defaulted so that they do not normally need to be adjusted.
You can block the Configuration menu against manipulation by an
appropriately parameterized and activated digital input. Which
parameters you need to set and all other parameters are explained in
chapter 4.4, page78Parameterization.
The configuration mode can be reported by outputting a
parameterizable fault message, a position feedback or output of limit
values A1 and A2 is not possible.
.
NOTE
If the electric power supply fails during configuration, the positioner
switches back to the first parameter after recovering the power supply,
values which have already been parameterized are retained. Without a
power failure you re--enter the configuration menu at the point you
exited it when you call the Configuration menu again.
at the same time
at the same time
at the same time
at the same time
to
Figure 4-5 Overview: Configuration
P-manual mode
(ex--factory state)
Configuration and
initialization