10 computer interface – Global Specialties PB-507 - Manual User Manual
Page 41

41
If more than 15 errors have occurred, the last error stored in the queue (the most
recent error) is replaced with “Queue overflow”. No additional errors are stored. If
no errors have occurred when you read the error queue, “No error” is displayed
in the error log.
List of errors:
•
E01: EEPROM does not respond.
•
E02: DAC 0 does not respond.
•
E03: DAC 1 does not respond.
•
E04: Function generator calibration data checksum error.
•
E05: Pulse generator calibration data checksum error.
•
E06: Power supply calibration data checksum error.
•
E07: Function generator calibration failed.
•
E08: Pulse generator calibration failed.
•
E09: Power supply calibration failed.
•
E10: USB controller initialization failed.
•
E11: Unexpected USB packet.
•
E12: USB packet ignored.
•
E13: USB header error.
•
E14: Power supply V+ error.
•
E15: Power supply V- error.
•
E16: Power supply 5V error.
•
E17: Error queue full.
10 COMPUTER INTERFACE
PB-507 has USB 2.0 compatible interface for remote control.
A Mini-B type USB connector is used to connect the PB-507 to a PC.
A companion Windows application, PB-507 Control Program and the required
device driver installer are available on the software CD. This application offers
full control of the following modules and settings: Function Generator, Pulse
Generator, Frequency Counter, DC Power Supplies, Logic indicators, Logic
probe, Hex to 7 Segment Decoder, Debounced Pushbuttons, Logic Switches,
SPDT Switches, Counter mode, Automatic save, Power-on, Front keys, Page
scrolling, Load default configuration.
Note that the USB device drivers for the PB-507 device must be installed prior to
running the PC application. To install the drivers, connect the PB-507 Trainer to