Global Specialties PB-507 - Manual - Manual (Page 33)

33
Figure 21
b. Two 4 digit numbers are shown on the display. Adjust the numbers until the
oscilloscope indicates the closest value to 10.0Vpp of the square signal and the
closest offset to zero.
c. Press the OK soft key to finish this step. The message “Step 5 done.” is
displayed on the screen.
8.1.6 Step 6
a. PB-507 will display:
Figure 22
b. Two 4 digit numbers are shown on the display. Adjust the numbers until the
oscilloscope indicates the closest value to 1.0Vpp of the square signal and the
closest offset to zero.
c. Press the OK soft key to finish this step. The message “Step 6 done.” is
displayed on the screen.
8.1.7 Step 7
a. PB-507 will display:
Figure 23