Global Specialties PB-507 - Manual - Manual (Page 28)

28
Note: If the PB-507 Trainer was previously unsecured, loading the default
configuration will secure the device with the last saved security code.
7.2 Memory menu
The Table 4 shows the Memory menu.
First level
Second level Third level Description
Back Go Back to the PB-507 main
menu
Store state Back Go Back to the first level
The states
numbered
from 1 to 10 Back Go Back to the second level
Enter name Select this option to Enter a
name for the selected state.
Save state Select this option to save the
selected state
Recall state Back Go Back to the first level
The states
numbered
from 1 to 10 Recall the selected state
Delete state Back Go Back to the first level
Delete all Select Delete all to delete all
states
The states
numbered
from 1 to 10 Delete the selected state
Table 4
7.2.1 State storage
The PB-507 Trainer has ten storage locations in non-volatile memory to store
states. The locations are numbered from 1 to 10.
You can store a state in any of the ten storage locations, but you can only recall
a state from a location that contains a stored state. “Empty location.” message
will appear if you try to recall a state from a location that not contains a saved
state.
The storage locations are not affected by the Load default configuration
command. Once a state is stored, it remains until it is overwritten or specifically
deleted. You can delete all the states at once by selecting Delete state 
Delete all option.
To save the current state, go into Store state menu, select a location from 1 to
10, and select Save state option from the menu. The message “State stored.”
will appear.