Global Specialties PB-507 - Manual - Manual (Page 32)

32
b. Two 4 digit numbers are shown on the display. Adjust the numbers until the
oscilloscope indicates the closest value to 1.0Vpp of the sine signal and the
closest offset to zero.
c. Press the OK soft key to finish this step. The message “Step 2 done.” is
displayed on the screen.
8.1.3 Step 3
a. PB-507 will display:
Figure 19
b. Two 4 digit numbers are shown on the display. Adjust the numbers until the
oscilloscope indicates the closest value to 1.0Vpp of the sine signal and the
closest offset to zero.
c. Press the OK soft key to finish this step. The message “Step 3 done.” is
displayed on the screen.
8.1.4 Step 4
a. PB-507 will display:
Figure 20
b. Two 4 digit numbers are shown on the display. Adjust the numbers until the
oscilloscope indicates the closest value to 0.1Vpp of the sine signal and the
closest offset to zero.
c. Press the OK soft key to finish this step. The message “Step 4 done.” is
displayed on the screen.
8.1.5 Step 5
a. PB-507 will display: