Burkert Type 8032 - Manual (Page 26)

ENGLISH ENGLISH
remote flow rate controller 8032
OHI>
OLO
0......9
ENTER
1
ENTER
0......9
ENTER
0......9
2
ENTER
ENTER
ENTER
ENTER
ENTER
0......9
0......9
ENTER
ENTER 0......9 0......9
0......9
ENTER ENTER ENTER
0......9
ENTER
ENTER ENTER
ENTER
ENTER ENTER
0......9
...
ENTER
0......9
ENTER ENTER
ENTER
ENTER
ENTER ENTER
0......9
0......9
*
*
* *
* *
to enter the K-factor of the
measuring device or have it
calculated through the Teach-
in feature**�
K is the multiplication coeffi-
cient between the frequency
transmitted by the remote
sensor and the flow rate to be
measured�
ProGramminG
. calibration mode
to choose the flow rate unit
(l/s, l/min, l/h, m 3 /min, m 3 /h,
Ga/s, Ga/min, Ga/h)�
to go back to the previous
feature�
to go to
the next function�
if you change the flow rate unit,
change the switching threshold
values, too.
UNIT l/s
GA/H
KFAC
NO
TEAC
YES
TEAC TEAC
0.534
KFAC
200.0
VOL
0.534
KFAC
** To use the «Teach-In» feature, connect the 8032 controller to a valve which makes it possible to fill a tank with a capacity of
x litres (200 litres for instance)�
When the display shows «YES TEAC», press the «ENTER» key and open the valve: The «TEAC» message flashes�
When the tank is full (200 litres), press «ENTER» again� By means of keys
0......9
and
ENTER
enter the volume of fluid which
circulated through the circuit (200 litres): the controller calculates the K factor and displays it�
**
* To move the decimal point, press simultaneously keys
0......9
and