Burkert Type 3005 - Manual (Page 6)

6
GeneralInformation
• Take appropriate measures to prevent electrostatic charges in
the EX area.
• Clean the device surface by wiping it gently with a damp or
antistatic cloth.
General hazardous situations.
To prevent injury, ensure:
• That the system cannot be activated unintentionally.
• Installation and repair work may be carried out by authorized
technicians only and with the appropriate tools.
• After an interruption in the power supply or pneumatic supply,
ensure that the process is restarted in a defined or controlled
manner.
• The electromotive rotary actuator Type 3005 must not be used in
areas where there is a risk of explosion (in this case please use
type 3004).
• Do not put any loads on the body (e.g. by placing objects on it
or standing on it).
• Do not make any external modifications to the device bodys. Do
not paint the body parts or screws.
• Do not install the actuator with the cover facing down (head first).
• The device may be operated only when in perfect condition and
in consideration of the operating instructions.
• The general rules of technology apply to application planning
and operation of the device.
5. General information
5.1. contact address
Germany
Bürkert Fluid Control Systems
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
international
Contact addresses can be found on the final pages of the printed
operating instructions.
And also on the internet at:
www.burkert.com
5.2. Warranty
The warranty is only valid if the electromotive rotary actuator Type
3005 is used as intended in accordance with the specified application
conditions.
5.3. information of the internet
The operating instructions and data sheets for Type 3005 can be found
on the Internet at:
www.burkert.com
english
Type 3005