Burkert Type 8025 - Manual (Page 25)

25
Installation
Type 8025 / 8035
7.3. installation of a panel version of the 8025 flowmeter
install the panel version of the device in a cabinet with a protection class at least ip54 to ensure a degree of
pollution 2 inside the cabinet.
→
To cut the opening in the cabinet door, use the supplied cutting plan of the frontage of the electrical cabinet, respecting
the dimensions indicated in "Fig. 13".
95
80
76
50
95 80 76 50
Fig. 13: Dimensions [mm] of the electrical cabinet frontage cutting plan
Seal
Nut
Washer
Screw
Cable clip
Fig. 14: Installation of a 8025, panel version
→
Insert the 4 screws in the housing (from the front). If the cabinet door is too thick use the 4 supplied M4*25 screws.
→
Insert the seal on the external threads of the 4 screws (rear of the housing).
→
Put the assembly on the cutout, electronics turned to the inside of the cabinet.
→
Put the 4 washers on the 4 screws.
→
Put a nut on each of the 4 screws and tighten the nuts to secure the device to the cabinet.
→
Wire according to the instructions in chapter "8".
English