Burkert Type 8644 - Manual (Page 56)

56
Installation
8.3. installing the airline system (e.g. in the control
cabinet)
NoTE!
• Before installation, check that the fastening rail is anchored firmly in the control cabinet or in the system.
• Observe the specifications in the configuration file for the installation sequence.
→
Connect all electrical modules/terminals on the left of the valve block to the standard rail according to the manu-
facturer's specifications.
→
Check that the last module in front of the valve block is a power module.
→
Place the valve block on the standard rail and slide it onto the already installed assembly until the lock hook
clicks into position.
→
Hold the valve block firmly and tighten the fastening screws clockwise.
→
The AirLINE system ends with the end module of the ET200S. Place the end module on the right of the valve
block and slide it onto the right pneumatic interface until the lock hook engages.
→
The installation of the AirLINE system on the standard rail is now complete.
The valve block is not connected securely to the standard rail before the fastening screws are tightened.
During the entire installation ensure that it cannot fall down.
8.4. changing the function module
DANgEr!
danger – high pressure!
• Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines.
risk of short-circuit!
• Do not insert any foreign objects into the base module (24 V supply bus)!
The function module is a component of the electronic base module. It can be replaced in consideration of the points
listed below:
→
Depressurize AirLINE system.
→
Using a screwdriver, loosen the fastening screws of the valves.
→
Remove valve from the valve plug.
→
Flange seal and O-ring must not be soiled.
→
Detach function module above rear catch mechanism and remove vertically without tilting it from the distributor
module (backplane bus).
english
Type 8644