Burkert Type 8643 User Manual
Page 31

31
Configuring the network
The bits of the bit string are assigned to the following alarms:
Bit
Alarm
0
Discrete alarm (LSB)
1
HI_HI_Alarm
2
HI_Alarm
3
LO_LO_Alarm
4
LO_Alarm
5
reserved
6
reserved
7
Block Alarm (e.g. increase of St_Rev)
8-15
reserved
Parameter description of the physical block
9.2.1.4.
parameter
parameter description
DEViCE_iD
Identification of the field device
DEViCE_man_iD
Identification code of the field device manufacturer (Bürkert = 120)
DEViCE_sEr_num
Serial number of the manufacturer
Dianosis
Precise information on the device, coded bit by bit.
Dianosis_mask
Definition of supported DIAGNOSIS information bits
0 = not supported
1 = supported
Dia_mEm_Chksum
Storage error
Dia_Conf_inVal
Invalid configuration
Dia_Warmstart
Warm start
Dia_ColDstart
Cold start
harDWarE_rEVision
Version number of the hardware for the field device
softWarE_rEVision
Version number of the software for the field device
Dianosis_EXtEnsion
Additional diagnosis for device manufacturer
Dianosis_mask_
EXtEnsion
Definition of supported information
faCtory_rEsEt
1
Reset to standard values
2506
Warm start
2712
Reset the bus address, IDENT_NUMBER_SELECTOR is not reset
parameter
Parameter description
DEsCriptor
User-definable text to describe the device within the application
english
Type 8643 PA