Burkert Type 8643 - Manual (Page 26)

26
Configuring the network
Configuring ThE nETWork 9.
storage allocation for user data transfer 9.1.
Basis: Handbook for your PLC
To implement the correct settings of the configuration program, copy the device-specific file (buer6521.GSD)
→
from Bürkert into the directory which contains the configuration software. To read in and process the configu-
ration, please read the documentation for your PLC or your control system.
Further information on the storage allocation can be found in the handbook.
system parameters 9.2.
All profile data refers to the profile version 3.0 class B.
This is where you will also find detailed documentation on the parameters.
When writing parameters, ensure that the power is on! •
Physical block 9.2.1.
slot 0 9.2.1.1.
parameter type:
n
Non-volatile parameter which must be observed in the operating cycle.
However, it does not belong to the static updating code.
s Static, non-volatile; the version counter ST_REV is increased during the write
process.
D (dynamic) The value is calculated in the block or read from another block.
C (constant) The parameter does not change.
english
Type 8643 PA