FlexLink X45 Руководство пользователя - Manual (Page 33)

Mounting, installation, adjustment
Create
d
by EBCCW
0
0
:06
25 5113196-2
5.3 Assembly of modules
The modules are to be assembled according to the system layout.
Find the correct position for connecting modules using the measurements
in section 5.3.3 on page 28 to section 5.3.8 on page 32
When assemble the parallel conveyors use the beam spacer XUCD 15x20
(see picture below). The distance between the spacers is to be approxi-
mately no more than 600 mm
Note that it is very important that the modules lines up horizontal according
to picture (A) below.
To avoid incorrect readings from the sensors that are used for detecting the
puck, guide rails must be mounted transversely to the beam, according to
picture (B) below.
A B