EXP Computer ThinFax LXM - Manual (Page 7)

NOTICE
:
What type of your telephone line ANALOG OR DIGITAL?
Check your telephone line, the Fax/Data can be connected to an ANALOG Line
ONLY ! (normal house hold line)
Testing the Modem
To verify that the modem has been installed and functions properly, please follow
these steps:
1. Press &… , C to start the DataComm program.
2. Press MENU, C, S to select the COM port setting in the
Interface field for COM 2.
Press TAB to move the highlight to OK and press ENTER to
accept the information entered.
3. Type AT then press ENTER.
The ThinFax modem should respond with an OK.
If the modem does not respond, please verify that the COM port
is set for COM 2 and redo the installation procedure.
4. Connect the slim connector to the modem card with the
RJ-11 end to a working telephone jack.
5. Type ATDT nnn nnnn then press ENTER, where nnn nnnn is
your telephone number. The modem will attempt to dial and
later it should display BUSY result code.
After you have finished the above procedures, this is proof that the modem is installed
properly and functioning well.
User type in these lines
Modem’s responses