EXP Computer ThinFax LXM - Manual (Page 29)

Use the key combination, CTRL + SHIFT + ON, to re-initialize the system. Do
not initialize the RAM disk or you will lose everything in your
AC@ drive.
10) How much space does the MiniFax software take up on my AAC@@ drive?
None, it does not require any space on the AC@ drive. It requires ~64KB of
system memory.
11) How do I connect to a BBS?
Use DataComm to dial out to the BBS. Make sure it is set to COM 2, because
that is where the modem is. At the screen type
AATDT5551212@, where
A5551212@ is your BBS number. Parity, data bits and stop bits are to match the
settings of the BBS that you are calling. The most common settings are N,8,1.
12) Can I leave the modem card in the HP 100LX when not in use?
Yes you can. It will use up your battery faster though.
13) Can I use the other ThinFax e.g. 14,400/14,400 with my HP 100LX?
You can use it for data only. There is no fax software on the card. It may cause
the HP 100LX to lock up if DataComm is started with the modem inserted. Just
start DataComm first then turn off the HP 100LX and insert the modem. It
should then be fine when you turn it back on to use DataComm. Remember to
have the AC adapter power your HP 100LX.
14) An ERROR AACannot find application to open@@
Make sure the ThinFax card is inserted.
MiniFax program reside in the A: drive. If you use any FLASH card, check its
device driver is in the config.sys or autoexec.bat file and make sure that the
FLASH card does not assign it to the A: drive.
15) I don ==t like the fonts on Cover Page. Can I change it?
No, not at the current production of the ThinFax card.
16) ThinFax is not on the list of supported modem. What is the initialize
string?
AT&F &C1 &D2
For more advanced modem operation see Section 5
>Operating Mode=
17) I have a FLASH card from another manufacturer. How do I install the
ThinFax LXM card?
You need to load EXP FLASH card device driver ( lxmdrv.sys ) after the other
FLASH card
=s device driver.