EXP Computer ThinFax LXM - Manual (Page 13)

RECEIVING FAXES
This section explains in detail the steps required to receive faxes.
NOTE: The MiniFax requires space in the C: drive to store the received fax.
Depending on the received fax's resolution, approximately 35KB
(standard mode, 200 x 100/200 dpi) or as high as 95KB (fine mode 200 x
200 dpi) of the disk's space will be needed for a one page (letter size) fax.
# # Press MENU, F, R or F3 or from any other MiniFax menu to display the
following screen
To receive fax
1. Observe the Operation:, and Response: during the initial setting of the ThinFax.
The ThinFax should always respond with OK.
2. At the end of setting up the ThinFax for reception, the status will display
'Waiting For call...' You are now ready to receive a fax.
3. The receiving fax will be stored at C:\_DAT (Default path). To change the path
of the received fax, user must use the MiniFax =s Configuration utility.
Press MENU, U, C, to access the configuration screen.
Change the Recv path to your choice.
Receiving fax
=s file name format consists of the current month, date, hour and
minute setting in the palmtop. 02220937.mfx (mmddhhmm)
Receive Fax Entry
# # File Name: This entry is the file name of the receiving fax. The file name will be
created by MiniFax when a fax is received.
# # Operation: This entry shows various commands or activity being sent to the
ThinFax 1414-LXM/LX.
# # Response: This entry is for the response from ThinFax 1414-LXM/LX
#
# Status: The status shows the state of the receiving function.
#
# Pages: This entry shows number of page(s) received.