beautypg.com

Draw-Tite 118401 T-ONE CONNECTOR User Manual

Draw-Tite For the car

background image

4. Locate a suitab

le grounding point near

the connector such as the vehicle's
frame or cross member. (Do not drill
into vehicle floor or bed.) Clean dirt and
rustproofing from area. Drill a 3/32" hole
and secure

white wire using e

yelet and

screw provided.

CA

UTION

V

erify what is behind any surface prior

to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.

5. Mount the

T-Connector black box using

double-sided tape provided. Secure the
remainder of the T-Connector harness
with the cable ties provided, to prevent
damage or rattling and being careful to
avoid any areas that would pinch, cut
or melt the wire.

W

ARNING

All connections m

ust be complete for the

T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.

W

ARNING

Ov

erloading circuit can cause fires.

DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.

Installation Instr

uctions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

18401-037

Rev. A

03/22/05

ENGLISH

TOOLS REQUIRED:

Philips Head Scre

wdriver, Drill (3/32" Drill Bit)

1. Under

neath the vehicle, on the

passenger’s side, between the bumper
and rear tire, locate the vehicle Tow-Plug
harness

d

.

It will have a connection

point matching the T-Connector harness.
Remove protective cap, being careful not
to break the locking tabs. All connector
surfaces should be clean and free of dirt.

2. Inser

t the T-Connector harness into

the vehicle’s Tow-Plug harness and lock
into place. Be careful not to damage the
locking tabs and be sure that connectors
are fully inserted with locking tabs in place.

3. Route the

T-Connector harness rearward

to the back of the fascia of the bumper.
Route the T-Connector harness along
the inside of bumper toward the center
of vehicle

e

.

W

ARNING

Route the wire being careful to a

void

any hot pipes, heat shields, the fuel
tank or any other points that may
pinch or break the wire.

READ

THIS FIRST:

Read and f

ollow all instructions carefully

before beginning installation.

LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr

uctions

attenrivement avant le montage.

LEA

ESTO PRIMERO:

Lea y siga todas las instr

ucciones cuida-

dosamente antes de iniciar la instalación.

d

e