Draw-Tite 118433 T-ONE CONNECTOR - Manual

4. Route the T-Connector end with green wire to
the passenger 's side behind the panels and
along the threshold. Repeat step 3 using the
T-Connector ends containing the green wire.
5. Locate a suitable grounding point near
the connector. Clean dirt and rustproofing
from the area. Drill a 3/32" hole and secure
the white wire using the eyelet and screw
provided
e.
CAUTION
Verify what is behind any surface prior to
drilling to avoid damage to the vehicle and/
or personal injury. Do not drill into any
exposed surfaces.
WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed. For initial test, reset vehicle
electrical system by temporarily removing
the key from the ignition.
6. In the Driver’s side storage area, clean a flat
area using a mixture of rubbing alcohol and
water. Mount the T-Connector black box using
double-sided tape provided
e.
7. Route the 4-Flat from below the threshold
plate into trunk. Store there when not
in use.
8. Reinstall felt trunk liner, threshold, and
other items removed during installation,
being careful not to pinch or cut the wires.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual & instruction
sheet for additional information.
118433-037 Rev. A 02/14/07
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, Drill (3/32” Drill Bit),
Philips Head Screwdriver, Test-probe
1. Open trunk. Temporarily remove the rear
threshold plate. Partially remove the felt
trunk liner behind the taillights
d.
2. On the driver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness. The taillight wiring harness will have
a connection point, on both sides, matching
the ends of the T-Connector. Separate this
connector, being careful not to break the
locking tabs. All connector surfaces should
be clean and free of dirt
e.
3. On the driver's side, insert the T-Connector
end, with the yellow wire, between the
vehicle wiring connectors and lock into place.
Be careful not to damage the locking tabs
and be sure that connectors are fully inserted
with locking tabs in place.
•
d
•
e
READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
Kia Elantra