beautypg.com

Draw-Tite 118425 T-ONE CONNECTOR User Manual

Draw-Tite For the car

background image

5. Reinstall the taillight housing assemblies,

positioning the vehicle wiring harness
between the housing and the vehicle body.
Secure the remainder of the T-Connector
harness under the bumper with cable ties
provided, being careful to avoid any areas
that would cut or pinch the wire.

NOTE
Mount 4-Flat in a suitable location
under the vehicle. Bracket not included.

WARNING

Overloading circuit can cause fires.
DO NOT exceed lower of vehicle
manufacturer rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.

3. On the Driver’s side, route the T-Connector

end with the green wire and the wire with the
4-Flat connector down through the opening
between the vehicle bumper and body

f.

Route the T-Connector end with green wire
to the passenger’s side and route the 4-Flat
underneath the bumper. Route T-Connector
end with green wire up through the opening
on the passenger side, being careful to avoid
any hot pipes, heat shields, the fuel tank or
any other points that may pinch or brake the
wire. Repeat step 2.

4. Locate a suitable grounding point near the

connector. (Do not drill into vehicle floor or
bed.) Clean dirt and rustproofing from area.
Drill a 3/32" hole and secure white wire
using eyelet and screw provided.

CAUTION

Verify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.

WARNING

All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.

118425-037

Rev. A

01/30/07

ENGLISH

TOOLS REQUIRED:

Trim Panel Remover, Drill (3/32” Drill Bit),
Philips Head Screwdriver, Test-probe

1. Open the tailgate and remove the vehicle’s

right side taillight assembly by removing
the two clips holding the taillight in place.
Carefully pry the housings away from
the vehicle, being careful not to break
the alignment tabs. Repeat for the
vehicle’s left side taillight assembly

d.

2. Disconnect the vehicle wiring harness from

both taillight sockets. Plug the T-Connector
end with the yellow wire in-between the
mating plugs on the Driver’s side taillight
socket and vehicle wiring harness

e.

All connector surfaces should be clean and
free of dirt. Ensure that the connectors are
fully inserted with locking tabs in place.

d

e

f

READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.

LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.

LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.

Installation Instructions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T