beautypg.com

Draw-Tite 118394 T-ONE CONNECTOR User Manual

Eg h

background image

ENGLISH

TOOLS REQUIRED:

T

-20 Torx

®

Bit and Driver

1. Open the rear tailgate to access the

screws that hold the taillights in place.
Remove the T-20 Torx

®

screws

de

and

carefully pry the taillight housings rearward
away from the vehicle, being careful not to
break the alignment tabs.

f

2. Access the b

lack housings that match

the housings on the T-Connector.

g

Disconnect the wire har

ness from both

taillight sockets. All connector surfaces
should be clean and free of dirt.

3. Locate a suitab

le grounding point on

the driver's side near the connectors.

h

Dr

ill a 3/32" hole and secure

white wire

with eyelet using screw provided.

CA

UTION

V

erify what is behind any surface prior

to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.

4. Beginning on the dr

iver’s side, plug the

T-Connector harness containing the

y

ellow

wire in betw

een the vehicle’s

mating connectors.

5. Route the har

ness containing the

green

wire and the 4-flat do

wn the opening

behind the taillight on the driver’s side.
Route the 4-flat harness to the center
of the vehicle. Route harness containing
the

green wire under

neath the vehicle

up through the opening behind the
passenger’s side taillight.

W

ARNING

Route the wire being careful to a

void

any hot pipes, heat shields, the fuel tank
or any other points that may pinch or break
the wire.

6. Repeat step 4 f

or the passenger’s side

using the T-Connector harness end with
the

green wire

.

W

ARNING

All connections m

ust be complete for the

T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.

7. Secure wires with cable ties provided.

Secure convertor (black box) through
the driver’s side taillight pocket, in the
area below the taillight and between the
vehicle and the bumper. Re-install both
rear taillights.

W

ARNING

Ov

erloading circuit can cause fires. DO

NOT exceed lower of towing manufacturer
rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5.0 amps)
Read vehicle's owners manual and
instruction sheet for additional information.

18394-037

Rev. A

09/04/04

f

d

Installation Instr

uctions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

READ

THIS FIRST:

Read and f

ollow all instructions carefully

before beginning installation.

LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr

uctions

attenrivement avant le montage.

LEA

ESTO PRIMERO:

Lea y siga todas las instr

ucciones cuidadosa-

mente antes de iniciar la instalación.

e

g

h