Draw-Tite 118416 T-ONE CONNECTOR - Manual

4. On the dr iver’s side, route the T-Connector
end with the 4-Flat down through the taillight
pocket between the bumper and body and
towards the center of the bumper. Secure
wires with cable ties provided.
5. Secure the remainder of the T-Connector
harness with the cable ties provided, to
prevent damage or rattling and being
careful to avoid any areas that would
pinch, cut or melt the wire.
Secure all loose wires and mount the
Trailer Tow Harness in an accessible location
with a bracket or electrical box (not included).
W ARNING
All connections m ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
6. Reinstall the taillight remo ved in step 1.
W ARNING
Ov erloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
ENGLISH
TOOLS NEEDED
Scre wdriver & Drill (3/32” Drill Bit)
1. Star ting on the driver's side, remove the
screws that hold the taillight in place d.
Carefully pull the taillight away from
the vehicle to expose the vehicle wiring
harness connectors in the pocket behind
the taillight
e.
2. Separ ate the vehicle's wiring connectors,
being careful not to break the locking
tabs
f.
Check to see that the mating surfaces
of the vehicle wiring connectors match the
T-Connector ends. All connector surfaces
should be clean and free of dirt. Plug
harness into connectors found in step 1.
Be careful not to damage the locking
tabs and be sure that connectors are
fully inserted with locking tabs in place.
3. On the dr iver’s side, locate a suitable
grounding point near the connector such
as an existing ground stud or drill a 3/32”
hole and secure the
white wire using the
eyelet and screw provided. (Do not drill
into vehicle floor or bed.) Clean dirt and
rustproofing from area.
CA UTION
V erify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
118416-037 Rev. A 08/28/06
•
d
•
e
•
f
READ THIS FIRST:
Read and f ollow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et obser
ver toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las adv ertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
Installation Instr uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T