Draw-Tite 118441 T-ONE CONNECTOR - Manual

5. On driver’s side, locate a flat surface in
an out of the way place and mount the
T-Connector’s black convertor box with
the double sided tape.
WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
6. Reposition the trunk liner and reattach the
threshold panel.
NOTE
Store 4-Flat in trunk area when not in use.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
118441-037 Rev. B 08/06/07
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, Screwdriver,
Drill & Wrench
1. Open trunk and remove threshold panel.
Partially remove the felt trunk liner on
driver’s side, exposing the taillight wiring
d.
2. Separate the harness connectors, being
careful not to break the locking tabs e.
3. Insert the T-connector between the harness
connectors and lock into place (Note: the
single plug-in for the right turn function
is on the driver’s side). Be sure that the
connectors are fully inserted with locking
tabs in place.
4. Use the existing ground stud or locate a
suitable grounding point. Drill a 3/32" hole
and secure the white wire using the eyelet
and screw provided.
CAUTION
Verify what is behind any surface prior to
drilling to avoid damage to the vehicle and/
or personal injury. Do not drill into any
exposed surfaces.
•
d
•
e
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T