Draw-Tite 118400 T-ONE CONNECTOR User Manual
Draw-Tite For the car

4. Begining at the Dr
iver's side taillight
pocket, route the harness containing
the
green wire and the 4-Flat do
wn the
opening between the vehicle bumper
and body
g
.
Route the 4-Flat harness to
the center of the vehicle. Route harness
containing the
green wire under
neath the
vehicle up through the opening between
the vehicle bumper and body to the
passenger’s side taillight pocket.
W
ARNING
Route the wire being careful to a
void
any hot pipes, heat shields, the fuel tank
or any other points that may pinch or break
the wire.
5. Repeat step 3 f
or the passenger’s side
using the T-Connector harness end with
the
green wire
.
6. Locate a suitab
le grounding point
near the connector such as the vehicle's
frame or cross member. (Do not drill
into vehicle floor or bed.) Clean dirt and
rustproofing from area. Drill a 3/32" hole
and secure
white wire using e
yelet and
screw provided.
CA
UTION
V
erify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
W
ARNING
All connections m
ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
Installation Instr
uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
18400-037
Rev. A
03/21/05
ENGLISH
TOOLS REQUIRED:
Scre
wdriver & Drill (3/32" Drill Bit)
1. Open the tailgate and remo
ve the vehicle’s
taillights. Carefully pry the housings away
from the vehicle, being careful not to break
the alignment tabs
d
.
2. On the dr
iver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness
e
.
The taillight wiring harness
will have a connection point, near each
taillight housing, matching the ends of
the T-Connector. Separate this connector,
being careful not to break the locking
tabs. All connector surfaces should be
clean and free of dirt
f
.
3. Beginning on the dr
iver’s side, plug
the T-Connector harness containing
the
y
ellow
wire in betw
een the vehicle’s
mating connectors. Be sure that the
T-Connector is fully inserted with
locking tabs in place.
7. On the Dr
iver’s side, mount the
T-Connector Black Box using the
double-sided tape provided. Secure the
remainder of the T-Connector harness
with the cable ties provided, to prevent
damage or rattling and being careful to
avoid any areas that would cut or pinch
the wire.
8. Reinstall the taillight housing
assemblies, positioning the vehicle
wiring harness between the housing
and the vehicle body.
W
ARNING
Ov
erloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light:
1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
READ
THIS FIRST:
Read and f
ollow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr
uctions
attenrivement avant le montage.
LEA
ESTO PRIMERO:
Lea y siga todas las instr
ucciones cuida-
dosamente antes de iniciar la instalación.
•
d
•
e
•
g
•
f