beautypg.com

Draw-Tite 118495 T-ONE CONNECTOR User Manual

Draw-Tite For the car

background image

READ THIS FIRST:

Read and follow all vehicle warnings and

installation instructions before beginning installation.

Wear safety glasses and use all safety precautions

during installation.
LISEz CECI En PREmIER:

Lire et observer toutes les consignes de sécurité et les

instructions avant de commencer l’installation. Durant

l’installation, veiller à toujours porter des lunettes

de protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:

Lea y siga todas las advertencias e instrucciones

de instalación del vehículo antes de empezar la

instalación. Use gafas de seguridad y todas las

precauciones de seguridad durante la instalación.

118495-037

Rev. A

10/15/09

Installation Instructions

Directives de montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

Dodge Journey

ENGLISH

TOOLS REQUIRED:

Trim Panel Remover, 10mm Socket & Ratchet or
10mm Wrench, Drill (3/32” Drill Bit), Test-probe

1. Open the tailgate and remove the vehicle’s right

side taillight assembly by removing the two
clips holding the taillight in place d. There will
be connection points matching the ends of the
T-Connector adapter behind each of the vehicle
taillight housings. e

2. Beginning on the driver’s side, separate the

vehicle’s wiring connectors, being careful not to
break the locking tabs. Insert the T-Connector
between the vehicle connectors. All connector
surfaces should be clean and free of dirt.

3. Beginning on the driver’s side, plug the T-Connector

harness containing the yellow wire in between
the vehicle’s mating connectors. Ensure that the
connectors are fully inserted with locking tabs in
place.

4. Route the harness containing the green wire and

the 4-Flat down the opening behind the taillight on
the driver’s side. Route the 4-Flat harness to the
center of the vehicle. Route harness containing
the green wire underneath the vehicle up through
the opening behind the passenger’s side taillight.
Repeat step 2 for the passenger’s side using the
T-Connector containing the green wire.

d

e

5. Locate a suitable grounding point near the

connector such as an existing ground stud or drill
a 3/32” hole and secure the white wire using the
eyelet and screw provided. (Do not drill into vehicle
floor or bed.) Clean dirt and rustproofing from area.

CAUTIOn
Verify what is behind any surface prior to drilling to
avoid damage to the vehicle and/or personal injury.
Do not drill into any exposed surfaces.

WARnInG
All connections must be complete for the
T-Connector to function properly. Test and verify
installation with a test light or trailer once installed.

6. Store 4-Flat connector in spare tire compartment

when not in use. Bracket, 4-Flat Mounting, sold
separately

WARnInG
Overloading circuit can cause fires. DO NOT exceed
lower of towing manufacturer rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle’s owners manual & instruction sheet
for additional information.