Draw-Tite 118503 T-ONE CONNECTOR User Manual
Fh i d g
READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning installation.
Wear safety glasses and use all safety precautions
during installation.
LISEz CECI En PREmIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes
de protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
118503-037
Rev. A
05/13/2010
Installation Instructions
Directives de montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
Acura zDX
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, 10mm Socket & Ratchet or
10mm Wrench, Drill (3/32” Drill Bit), Test-probe
1. Open rear passenger side door and fold rear
seat down
d
. Remove passenger side rear door
threshold plate to locate bolt holding passenger
side seat bolster
e
.
2. Remove bolster by removing 10mm bolt and
pulling straight up on bolster being careful not to
damage the clips holding it in place
f
.
3. Locate grey 8 pin tow plug behind bolster it will
be taped to vehicle harness with blue tape
g
.
Insert the T-Connector harness into the vehicle’s
Tow-Plug harness and lock into place.
4. On passenger side, locate existing ground stud.
Loosen 10mm bolt, place screw eyelet on stud
and re-tighten bolt
g
.
5. WARnInG
All connections must be complete for the Trailer
Tow Harness to function properly. Test and
verify installation with a test light or trailer once
installed.
6. Route the 4-Flat through the passenger’s side
trim panel into rear storage compartment and
store there when not in use
h
.
7. Reinstall the plastic trim panels, threshold,
storage covers, floor covering and other items
removed during installation, being careful not to
pinch or cut the wires.
e
8. Locate the vehicle’s Passenger Compartment
Fuse Panel located under the hood behind the
windshield washer fill tube. Insert both 7.5 amp
fuses into slot #9 and #11 in the fuse box
i
.
WARnInG
Overloading circuit can cause fires. DO NOT
exceed lower of vehicle manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5.6 amps)
Read vehicle’s owners manual &
instruction sheet for additional information.
f
h
i
d
g