Draw-Tite 118419 T-ONE CONNECTOR User Manual
Draw-Tite For the car

5. Locate a suitab
le grounding point near
the connector. Clean dirt and rustproofing
from the area. Drill a 3/32" hole and
secure the white wire using the eyelet
and screw provided.
CA
UTION
V
erify what is behind any surface prior to
drilling to avoid damage to the vehicle and/
or personal injury. Do not drill into any
exposed surfaces.
W
ARNING
All connections m
ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
6. Route the 4-Flat from belo
w the threshold
plate into trunk. Store there when not in use.
7. Reinstall f
elt trunk liner, threshold, and other
items removed during installation, being
careful not to pinch or cut the wires.
W
ARNING
Ov
erloading circuit can cause fires. DO
NOT exceed lower of towing manufacturer
rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual & instruction
sheet for additional information.
ENGLISH
TOOLS NEEDED
T
rim Panel Remover
1. Open tr
unk. Temporarily remove the rear
threshold plate
d.
Partially remove the
felt trunk liner behind the taillights
e.
2. On the dr
iver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness
e.
The taillight wiring harness
will have a connection point, on both
sides, matching the ends of the T-Connector.
Separate this connector, being careful not
to break the locking tabs. All connector
surfaces should be clean and free of dirt.
3. On the dr
iver's side, insert the T-Connector
end, with the
y
ellow
wire
, between the
vehicle wiring connectors and lock into
place. Be careful not to damage the locking
tabs and be sure that connectors are fully
inserted with locking tabs in place.
4. Route the
T-Connector end with
green
wire to the passenger 's side behind the
panels and along the threshold. Repeat step
3 using the T-Connector ends containing the
green wire
.
118419-037
Rev. A
10/04/06
•
d
•
e
READ
THIS FIRST:
Read and f
ollow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et obser
ver toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.
LEA
ESTO PRIMERO:
Lea y siga todas las adv
ertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
Installation Instr
uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T